> ## Knowledge Base Index
> Fetch the complete knowledge base index at: https://leasup.crisp.help/sitemap.xml
> Use this file to discover available pages before exploring further.
> Pure-Markdown content can be obtained by appending a '.md' suffix to the content URLs listed in the sitemap (without the trailing slash).

# Limit the indexation: freeze, cap, floor, weighting

# Limit the indexation: freeze, cap, floor, weighting

![Limit the indexation: freeze, cap, floor, weighting](https://storage.crisp.chat/users/upload-1/plugin/-/8/e/b/d/8ebd4a2ac6bc5000/en-bandeau_a8hiwr.png "=1000xauto")

|| 🎯 **GOAL:** reproduce the lease clauses that limit indexation (temporary freeze, maximum increase or decrease, rent that cannot fall below the lease rent, share of the index applied) so that the amount calculated by Leasup is the one the lease allows.

| | |
|---|---|
| 👉 **Where** | Lease page › **Finance** › **Fixed rents & charges** › cost card › **Consult** › **Rent review mechanism** › **Advanced options** tab |
| 👤 **Who** | Every profile except **Observer**. |
| ✅ **Prerequisites** | An **indexation** or a **variation** already entered on the cost: the options frame it, they do not replace it. |
| ⏱️ **In practice** | When the lease or the amendment that provides for the clause is entered. |

**In this article**
* [1- The four options](#2-1-the-four-options)
* [2- Freezing the indexation](#2-2-freezing-the-indexation)
* [3- Capping the increase, limiting the decrease](#2-3-capping-the-increase-limiting-the-decrease)
* [4- The contractual floor](#2-4-the-contractual-floor)
* [5- The weighting](#2-5-the-weighting)
* [6- Combining the options](#2-6-combining-the-options)
* [7- Limits and points to watch](#2-7-limits-and-points-to-watch)
* [8- Case study: the indexation corridor](#2-8-case-study-the-indexation-corridor)

|| 💡 Looking for the **update** of the amount when the lease takes effect? See [Index a rent or a charge](/en/article/index-a-rent-or-a-charge-y5k2xa/), section 7, and [Create a rent or a fixed charge](/en/article/create-a-fixed-cost-iqafhp/).

---

## 1- The four options

The **Advanced options** tab offers four buttons:

| Button | The lease provides for… | Effect |
|---|---|---|
| **Add a revision freeze** | "indexation will not apply during the first two years" | No increase during the period. |
| **Add a revision cap and/or floor** | "the increase may not exceed 3% a year" | The variation is limited, upwards and/or downwards. |
| **Add a contractual floor** | "the rent may not be lower than the base rent" | The amount does not fall below the contractual amount. |
| **Add a revision weighting** | "80% of the variation of the index will be applied" | Only part of the variation is passed on. |

The number next to the tab counts the options saved.

## 2- Freezing the indexation

![Adding a revision freeze](https://storage.crisp.chat/users/upload-1/plugin/-/8/e/b/d/8ebd4a2ac6bc5000/en-gel-de-revision_1co6e0m.gif "=1000xauto")

1. **Advanced options** › **Add a revision freeze**.
2. **Freeze start date** and **Freeze end date**: both are required.
3. **Save**.

During the freeze, the indexation produces no increase. At the end of the freeze, there is **no catch-up**: the indexation restarts from the index at the end of the freeze, and the increase for the frozen period is lost.

## 3- Capping the increase, limiting the decrease

![Adding a 3% cap and floor](https://storage.crisp.chat/users/upload-1/plugin/-/8/e/b/d/8ebd4a2ac6bc5000/en-plafond-et-plancher_1xklbda.gif "=1000xauto")

1. **Advanced options** › **Add a revision cap and/or floor**.
2. **Start date**: **Effective date of the contract**, **Cost start date** (default) or **Specific date**.
3. **End date**: **No end date**, **Cost end date** or **Specific end date**.
4. **Cap type** and **Maximum increase**; and/or **Floor type** and **Minimum decrease**.
5. **Save**.

| Cap type | Floor type | What is limited |
|---|---|---|
| **At each revision period** | | |
| **Maximum increase in variation (%)** | **Maximum decrease in variation (%)** | the variation of one revision, in % |
| **Maximum increase in variation (amount)** | **Maximum decrease in variation (amount)** | the variation of one revision, in € |
| **Maximum adjusted amount** | **Minimum adjusted amount** | the amount after revision |
| **Maximum adjusted amount per surface** | **Minimum adjusted amount per surface** | the amount after revision, in € per m² |
| **Maximum adjusted amount per unit** | **Minimum adjusted amount per unit** | the amount after revision, per unit |
| **Over the full period** | | |
| **Maximum increase in variation (%)** | **Minimum decrease in variation (%)** | the cumulative variation since the start |

The **Index the cap** (or **Index the floor**) switch makes the limit change like another cost, the rent for example. It is used mainly for service charge caps: see **Plafonner des charges** (in French).

## 4- The contractual floor

The **contractual floor** stops the amount from falling below the contractual amount, even if the index falls.

1. **Advanced options** › **Add a contractual floor**.
2. **Start date** and **End date**, with the same choices as for a cap.
3. **Save**.

| ⭐ **LEASUP TIP:** do not mix up the two floors. The **revision floor** limits the decrease of a variation; the **contractual floor** protects a minimum amount.

## 5- The weighting

The **weighting** passes on only part of the variation of the index. It does not reduce the rent: it reduces the effect of the indexation.

1. **Advanced options** › **Add a revision weighting**.
2. **Weighting start date** and **Weighting end date**: required.
3. **Revision Weighting**: the share of the variation applied, in %. For example 80.
4. **Save**.

Example: the index rises by 3% and the lease weights the indexation at 80%. The rent rises by 2.4%.

## 6- Combining the options

Several options can apply to the same cost: a freeze for the first two years, then a cap on increases, for example. Each one must match a clause of the lease or of an amendment.

After each option, open the **Evolution** panel (history icon on the card) and check the amounts, the dates and the effect of the option on each revision.

## 7- Limits and points to watch

* The options only appear if the cost already has a **revision** (indexation or variation). A charge that does not change? Give it a 0% variation: see **Plafonner des charges** (in French).
* The dates of a freeze, a cap or a weighting must match those of the lease exactly.
* A clause that only works **upwards** raises a legal question before it is a set-up question: see [Understand the triennial rent review and indexation](/en/article/triennial-review-and-indexation-13kriam/).
* Do not add an option to correct a result: correct the indexation.

## 8- Case study: the indexation corridor

An amendment to the MERCATOSUD lease frames the annual indexation of the rent: the variation may not exceed 3% upwards, nor 3% downwards. In the first year of the amendment, the indexation is frozen.

| Step | What you do | What Leasup shows |
|---|---|---|
| 1 | **Advanced options** › **Add a revision freeze**, from 1 January 2027 to 31 December 2027 › **Save** | No increase in 2027, and no catch-up in 2028. |
| 2 | **Add a revision cap and/or floor**, **Cost start date**, **No end date** | — |
| 3 | Cap **Maximum increase in variation (%)**, 3; floor **Maximum decrease in variation (%)**, 3 › **Save** | An index at +4.2% only raises the rent by 3%. |
| 4 | **Evolution** panel | The adjusted amount of each revision stays within the corridor. |

---

## Going further
* 📘 [Index a rent or a charge](/en/article/index-a-rent-or-a-charge-y5k2xa/) — the revision the options frame
* 📘 [Change a cost with a variation](/en/article/variations-zoidsq/) — a change in % or in an amount
* 📘 **Plafonner des charges** (in French) — the indexed service charge cap
* 📘 [Understand the triennial rent review and indexation](/en/article/triennial-review-and-indexation-13kriam/) — upward-only clauses, sliding scale